RC Discussion Forums

In the Print Log Book:
1.
Under "Maintenance", there is a “Notes” area – where do you fill in data in that area?

2.
Wolud it be possible to show what "Maintenance Procedure" there is maked???


GREAT PROGRAM
tumbs up

Knud Pedersen
DENMARK

When you create a maintenance record you can add procedures and also add any notes you would like. There is a text block that allows you to enter anything you want. This will be printed in the report if you turn it on.

I am sorry but I do not understand your last question. Could you please re-phrase it?

Thanks
Shawn

Hi Slammers.

----------------------------------
Print Flight Log
------------------------------------

Regarding Question 1:
It is when “Print Log Book” .
There comes no text in the “Notes” right under the “Maintenance” linie.
I have add notes in the “Description of Maintenance or Adjustments” textbox.
I have added a Maintenance Procedure.
But there is NO text in the “Notes” (under the maintenance) when showing Print Preview of “Print Log book” .
(I have turn on the “Show Maintenance Notes)
??????
--------------------------------------------------------
Regarding Question 2:
If I have picked a Maintenance Procedure in the Flight Log under “Field Maintenance”, this isn’t showed in the “Print Log Book”
Only the “written text” from the “Description of Maintenance or Adjustments” is shown.
The chosen Procedure is not shown.
-------------------------------------------------------
Question 3:
There is many “Notes” textbox in the “Print Log Book” and “Print Maintenance Log” – would it be possible too expand the “Notes”, so that there is standing “Flight Log Notes”, “Maintenanse Notes” etc.
It is hard to remember from where the Notes comes…..


---------------------------------------------------
”Print Maintenance Logs”
---------------------------------------------------
4.
Would it be possible to have en line that separates between every Dates (like the Print Log book).


5.
Would it be possible to make a “Autotext” that shows if the maintenance was perform at the field or at the Workshop?
Or do I have to make a text in the procedure that tell? Example:
Procedure: Adjustments: Transmitter (Field)
Procedure: Adjustments: Transmitter (Workshop)

6.
Would it be possible to make a “Filter” to choose a specific “Maintenance Procedure“ (Like when printing the Log Book)??



Knud Pedersen
DENAMRK

I will check out these problems in the next few days and get back to you.

Thanks for the heads up. The reports are the most probalematic portion of this software. The report generator I use has many bugs. The reports break from time to time and I use them so infrequently that I miss these bugs.

Shawn

Hi Slammers

Regarding Print Log Book – NO text in the linie “Notes” underneath Maintenance:

It is “one and the same “ text box, this Maintenance and Notes at the bottom on each rows.
It is just separated into two lines (Maintenance and Notes….)
I just have to write a long text, or more lines, then there is coming text in the line “Notes”

BUT at the Print Log Book – there is standing ”Maintenance Notes” – and at the Print Maintenance Log there is standing “Details” – maybe it would be good if it was the same “text” in both Reports.
Maybe “Description of Maintenance” (?)

Knud Pedersen
Denmarks